Mike, the Jameco speaker actually screws right in where the old Corsair II
speaker was without modification/drilling/adapting? If so, that's amazing.
Tnx/73,
Barry N1EU
On Thu, Jan 3, 2013 at 11:48 AM, Mike Hyder -N4NT- <Mike_N4NT@charter.net>wrote:
> OK. Here's the skinny on the Jameco speakers, straight from a Jameco rep's
> mouth. The model 99995 which I purchased six of back in 2003 has been
> replaced by the Jameco model 99996. The only difference between the older
> and newer models is that the 99996 now available is "RoHS compliant," which
> means that it is free of lead (for any of you speaker eaters). I can now
> heartily recommend the Jameco model 99996 speaker as a direct replacement
> for the original internal speakers in older Ten-Tec rigs. I have put them
> in Tritons, Omni-C's, 580 Deltas and a Corsair II.
>
> Here again is the link to the speaker >
> http://www.jameco.com/webapp/**wcs/stores/servlet/Product_**
> 10001_10001_99996_-1?CID=**PDFSorry<http://www.jameco.com/webapp/wcs/stores/servlet/Product_10001_10001_99996_-1?CID=PDFSorry>for
> the confusion but the 5 did look exactly like a 6 on my speaker.73,
> Mike Hyder -N4NT------ Original Message -----From: "Mike Hyder -N4NT-" <
> Mike_N4NT@charter.net>To: "Ten-Tec Reflector" <tentec@contesting.com>Sent:
> Thursday, January 03, 2013 11:32Subject: Re: [TenTec] Replacement Speakers
> for Older TenTec Transceivers.> Sorry. After getting out my magnifier I see
> that the speaker number I usedwas the 99995 AND NOT THE 99996. I cannot
> vouch for the 99996. Sorry for theconfusion.>> 73, Mike N4NT>> -----
> Original Message -----> From: "Mike Hyder -N4NT-" <Mike_N4NT@charter.net>>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>> Sent:
> Thursday, January 03, 2013 11:28> Subject: Re: [TenTec] Replacement
> Speakers for Older TenTec Transceivers.>>>>I bought a number of these
> speakers from Jameco several years ago andinstalled several in Ten-Tec
> rigs. They fit perfectly and are st
> outerspeakers than the original. You can tell by the magnet structure.
> Here isthe link to the 99995 speaker at Jameco >
> http://www.jameco.com/webapp/**wcs/stores/servlet/Product_**
> 10001_10001_99996_-1<http://www.jameco.com/webapp/wcs/stores/servlet/Product_10001_10001_99996_-1>>>>>
> 73, Mike -N4NT->>>> ----- Original Message ----->> From: "Jack Van Demark" <
> wn5a@sbcglobal.net>>> To: <tentec@contesting.com>>> Sent: Tuesday,
> January 01, 2013 18:26>> Subject: [TenTec] Replacement Speakers for Older
> TenTec Transceivers.>>>>>>>I need a replacement speaker for my TenTec
> Argonaut 509. TenTec nolonger sells them. This one is a 2.5" diameter
> round 8 Ohm speaker. Hasanyone found a source that I can get a
> replacement.>>> Thanks>>> and Happy New Year>>>>>> Jack WN5A>>>>>>>>>
> ______________________________**_________________>>> TenTec mailing
> list>>> TenTec@contesting.com>>> http://lists.contesting.com/**
> mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
> >>>
>
> ______________________________**_________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/**mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|