TenTec
[Top] [All Lists]

Re: [TenTec] Paragon Problem gets very odd

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon Problem gets very odd
From: wade staggs <tvman1954@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 14 Jul 2012 12:51:47 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
*Amazing,*
*                That cap could have been breaking down under load. You
could have bad connections. I would look at ALL of the connections very
closely. Maybe, it saw you Armed with the proper service info and you
scared it into working ;) I am really glad that you are on the air. If, it
fails again, shake the service manual at it and give it a good cursing. You
may need to scare it some more.. Just Joking...*
*                                                    73 de Wade/KJ4WS*

On Sat, Jul 14, 2012 at 12:43 PM, Ben Hall <kd5byb@kd5byb.net> wrote:

> Morning all,
>
> An update.  So I got the power amp out of the Paragon, took it all
> apart, and inspected it.  I found no obvious damage - no swollen caps,
> no burn marks, etc...
>
> I did remove C25 (which was a 33uF, 35V, 105 deg C unit) and couldn't
> find a replacement in my supply.  C25 tested fine.  I ran it up to
> nearly 30 VDC and it did not short, did not leak, etc...
>
> But I could find nothing wrong, so I put it back together minus C25.
> With just the power amp on the bench, I hooked up 13.8VDC to the red lead.
>
> Everything was fine.  No power draw.  (insert head scratching here)
>
> So I put it back into the radio, hook up the RF output.  Apply power.
> No power draw on the red wire into the power amp.
>
> So I reattached the blue "11" plug and repeat.  No power draw.
>
> So I reattached the RF Input and repeat.  No power draw.
>
> So at this point, everything is hooked up minus the red power wire.  So
> I resolder it to the power board and apply power to the radio.
>
> It POWERS UP FINE.  Hooked it up to the dummy load, hooked up my mic,
> and it makes output power just fine.  Voice peaks into the dummy load
> easily hit nearly 100W.
>
> SoooOOOOooo!  I am now totally confused as to what's going on.  Best I
> can figure was maybe a loose connection from the bias board to the power
> amp?  VERY ODD.
>
> I am ordering some replacement caps from Mouser - will replace that 33uF
> and the 10uF ones with 50VDC, 105 deg C replacements...
>
> thanks much and 73,
> ben, kd5byb
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>