Perfect - thanks all!!
On Tue, Oct 20, 2020 at 2:54 PM Josh Gibbs <gibbsjj@gmail.com> wrote:
> Check out this thread:
>
>
> https://forums.qrz.com/index.php?threads/ten-tec-century-21-restoration.522748/page-11
>
> That guy used these screws:
>
> Steel Truss Head Machine Screw, Black Oxide Finish, Meets ASME B18.6.3, #2
> Phillips Drive, #10-24 Thread Size, 5/8" Length, Fully Threaded, Imported
> (Pack of 100)
> https://www.amazon.com/dp/B00FTJYDR8/ref=cm_sw_r_cp_tai_LHMxEb9PBYRZT
>
> -Josh WU7H
>
>
> On Tue, Oct 20, 2020 at 11:10 AM David Goncalves <davegoncalves@gmail.com>
> wrote:
>
> > Has anybody found a source for the truss headed machine screws used on
> the
> > C21 and original Omni cases? I cant find anything like it at the hardware
> > store or online.--
> > David Goncalves
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|