You could try a headphone attenuator.
On Mon, Aug 20, 2018 at 8:43 AM, <Rick@dj0ip.de> wrote:
> I must emphasize what Bob says about different headphones.
> I did this with my Eagle, trying about 6 different headphones.
> On some the noise was loud, some it was not very loud and on one it was
> inaudible.
>
> More important than how it sounds in some unrealistic state, is how it
> sounds when listening to a signal:
> 1) on a quiet band
> 2) on a crowded band
>
> 73,
> Rick, DJ0IP
> (Nr. Frankfurt, Germany)
>
> -----Original Message-----
> From: TenTec <tentec-bounces@contesting.com> On Behalf Of Bob McGraw K4TAX
> Sent: 20 August 2018 14:34
> To: tentec@contesting.com
> Subject: Re: [TenTec] Audio improvements on Argonaut VI
>
> I find the RX audio quality of the Argonaut VI to be exceptional when
> compared to other like radios. In comparing it to the Corsair II, you are
> comparing an analog radio to a digital radio. Yes there is and will be a
> difference. Accept the fact and get over it.
>
> As to hiss, the headphones do make a difference in what is heard. Be
> realistic in your evaluation. Do you operate with no antenna and the RF
> Gain to the left? I hope not. So, make your judgements with antenna
> connected and RF gain in various positions with regard to band noise.
>
> As to the pulsing noise when rotating the frequency encoder, it this heard
> with normal antenna and RF Gain? If not, then it is not an issue.
>
> Stop picking at stuff that isn't real under normal operating conditions.
> Try different headphones and you will get different results.
>
> 73
>
> Bob, K4TAX
>
>
> On 8/20/2018 6:47 AM, Carlos wrote:
> > Hi,
> >
> > I just bought an Argonaut VI and got disappointed with the received
> > audio (when comparing it with a Corsair II).
> >
> > When monitoring with headphones it improves a lot, but there is some
> > hiss in the background, even without antenna and the RF gain all the
> > way to the left.
> >
> > Do you guys think that I might have a damaged audio amplifier? Is
> > there an easy way to improve the received audio with the in-built
> > speaker? PBT/BW/NR settings are OK, I even performed a factory reset.
> >
> > Using headphones, I can hear a weak pulsing noise when rotating the
> > frequency encoder. Is there a way to eliminate that ?
> >
> > 73,
> > Carlos VK1EA
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|