I would say Art Collins did not agree with your assessment when he designed the
30S1. The problem of mismatch is often the result of the use of two or more
finals in the amplifier and their resulting parallel input impedance, and the
use of a solid state driver with a non tunable final transmitter stage. Collins
actually supplied the jumper cables which were different lengths for different
combinations of their drivers and the 30S1. You can read about the phase
transformation in the 30S1 manual. 73 and Happy DXing, Mike W2AJI
-----Original Message-----
From: Jim Brown K9YC
Sent: 5/31/2010 8:19:38 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Ten-Tec 411 Centaur Amp Problem
On Mon, 31 May 2010 15:55:31 -0400, wow_chf@hotmail.com wrote:
>I submitted the article draft to QST, and it was questioned by the Technical
>Review folks, and although I have been published in QST before, they could
>not see how this would "transform" the apparent input SWR.
Because it's a POOR fix for the fundamental problem, which is something wrong
in the input circuit of the power amp causing a mismatch. The proper fix is
to find and correct the problem in the input circuit. Adding coax is a band-
aid.
73,
Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|