> Tod,
>
> I using a normal 9-pin to 25-pin serial cable from the PC to the Omni
> VI. I think it is a "cross-over" cable but I'm not sure on that.
> I can
> check if you wish. I have mine set to 19200bps, 8 data bits, 1 stop
> bit. You also need to set the software up for an Icom IC-735. I've
> read that IC-703 may work also but I have not tried it.
I finally got it to work!! You can test you serial connection by
hooking up the cable, opening a term and then powering up the Omni
while holding the FM key.
I did this, and it must have kicked something, because the connection
now works.
----
Tod Glenn
N7WD
SKCC #1444
ARCI #12420
FISTS #12134
NAQCC #1283
n7wd@cordite.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|