Check the bias supply. Tubes should not show color at idle.
Bob, K4TAX
Sent from my iPhone
> On Aug 8, 2018, at 8:28 PM, Rodney <w3krq@dejazzd.com> wrote:
>
> no it was 190 m with no drive and tubes got red
>
> -----Original Message----- From: Bob McGraw K4TAX
> Sent: Wednesday, August 08, 2018 8:53 PM
> To: tentec@contesting.com
> Subject: Re: [TenTec] centurion
>
> Is this idle current with no signal? If so it is about correct.
>
> 73
>
> Bob, K4TAX
>
>
>> On 8/8/2018 7:42 PM, Rodney wrote:
>> I was on my Centurion talking and looked at my plate current it was resting
>> at 190m but the amp was putting out 1200w so tubes I think are ok.
>>
>> ---
>> This email has been checked for viruses by AVG.
>> https://www.avg.com
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|