Jack, see page 28 of the Orion manual:
"Pin 4 is line level audio output. Which
receiver(s) are output to here and the level
of audio sent to the jack are controlled by
the Line Out Src and Line Out Level
commands in the Other menu."
But...you only have three choices: High, Medium and Low. And, these are
fixed level outputs. You should use the audio output from the Orion
headphone jack instead of the Aux I/O and connect that to the YCCC SO2R box.
73, Ted W4NZ
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com]On Behalf Of jack
Sent: Saturday, December 15, 2012 1:35 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] audio from the I/O connection at the back of the Orion
Question: is there a way to turn down the audio gain from the I/O DIN
connection on the back the Orion?
I have 2 Orions and have them connected to a Yankee Clipper SO2R+ which
feeds the audio thru to headphones. turning down the main and sub AF gain
does NOTHING to the I/O gain thru the DIN connector.
there is much too much volume in the headphones. the output is so loud thru
the SO2R box that I can use the headphones as a speakers. in fact right now
I am listening without problem to a CW chat on 17 meters with the headphones
on the desk.
thanks,
jack
ak7o
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|