Ron,
The board appears to be clean from flux, but I will try and re-solder the pads
to see if that might help.
Thanks to all for the inputs.
73’s
Rich, WD6DOK
> On Apr 4, 2016, at 12:57 PM, Ron Kolarik <rkolarik@neb.rr.com> wrote:
>
> Try reflowing the solder or better yet clean off the old stuff and replace.
> I've had a few that bubbled like crazy from excessive flux when reheated.
>
> Ron K0IDT
>
>
> Message: 1
> Date: Sun, 3 Apr 2016 10:21:48 -0600
> From: Froiseth Richard<Rfwd6dok@centurylink.net>
> To: Discussion of Ten-Tec Equipment<tentec@contesting.com>
> Subject: [TenTec] Ten Tec Filters.
> Message-ID:<325DB1E2-CE32-4144-B072-57A1E0FE4DC6@centurylink.net>
> Content-Type: text/plain; charset=utf-8
>
> I have a 220 SSB Ten Tec filter for 9 MHz IF that doesn?t work.
> Is there any way to test the board to see what crystal is bad?
> I notice the crystals appear to be color coded. If so can the same colored
> crystal from another board be used?
> Where is a good place to get replacement crystals?
>
>
> 73?s
> Rich, WD6DOK
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|