Power off -
Disconnect one connector at a time, put a bit of deOxit on a Q-tip and wipe
the pins up and down both sides and reconnect. Do not spray the connectors
or pins. Do all the connections, then power back up.
When I had a problem with my Corsair's display, I called Ten-Tec and was
given the instructions and a can of deOxit. I'll look and see if I can find
those instructions.
--------------------------------------------------
From: "Richards" <jruing@ameritech.net>
Sent: Saturday, January 16, 2010 10:57 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Corsair AGC problem
> You mean to apply the de-oxit to only the pins and
> connectors, right ? One would not want to get the stuff
> inside the display components...right?
>
> ================ K8JHR =============================
>
> On 1/16/2010 10:38 PM, CSM(r) Gary Huber - AB9M wrote:
>> The frequency display is most likely another deOxit session for pins of
>> connectors of the display board, display driver, counter, time base, etc.
>
> ==================================================
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|