On the Paragon; I had one which developed similar "phase lock loop not
locked" symptoms. I sent it back to TT several times, but the fix is
relatively simple, make sure the boards are grounded. It may take reflowing
a bit of solder on the ground traces around the machine screw holes of the
boards, star washer lock nuts, a touch of De-Oxit, and tightening the
machine screws an eighth to quarter turn after head contact to insure the
star washer bites into the solder. I think some even soldered both sides of
the mounting holes, used longer machine screws, and put star washers on both
sides of the board. A yearly application of De-Oxit and checking /
retightening screws to maintain the grounds is a good idea.
73 es DX,
Gary - AB9M
-----Original Message-----
From: John Graves
Sent: Sunday, April 17, 2011 2:35 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Club Owned TenTec Equipment
My local club owns 3 TecTec transceivers, all of which have problems.
it is a shame because people want to try the rigs.
Our oldest is a Triton IV. Often enough to be really annoying, the VFO
quits and displays 9.000. Sounds like the the problem is in the
generation of beat signal but I am welcome to suggestions.
The next oldest , I think, is an original Century 21 that just sits
there. Given that it is a QRP rig I think it will be the last to be fixed.
The last is an original Paragon, a gift from a club member. On this
one, the display goes back and forth from a regular display to a phase
loop not locked message.
We have space for 3 stations and we hope to set one position up as an
all TecTec one. Suggestions welcome. Returning the Paragon and Triton
to home is not an option at present.
Thanks for your thoughts or suggestions.
--
John Graves
WA1JG
jh.graves@verizon.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|