Apologies for the elementary question, but with 3.033xa running (and
even that was installed by the factory, after service) I obviously don't
do this very often. Now trying to go to xe.
I'm using an old Windows XP laptop with a cable from the O-2's serial
port to a laptop USB port through an adapter. After trial and error I
found that COM3 did not give me a "Port not found" error, so I'm using
that. The "Ten-Tec Flash32 Flash Update Utility" seems to be running,
and the laptop screen shows a "11175 total data lines in file" message.
A couple of the laptop lights are blinking; one looks like a disk icon
and another like a battery.
But there's no action showing on the Orion screen --- just "FLASH UPDATE
MODE" and "Press any key to exit." From previous work I remember
progress being shown on the O2 screen, as the manual says it should be.
Suggestions?
-- John K3GHH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|