TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI Howling Noise

To: tentec@contesting.com
Subject: Re: [TenTec] Omni VI Howling Noise
From: Bob McGraw K4TAX <rmcgraw@blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 26 Oct 2018 19:26:25 -0500
List-post: <mailto:tentec@contesting.com>
Still something loosing contact somewhere.  A component failure wouldn't normally respond in that manner.

73

Bob, K4TAX


On 10/26/2018 7:19 PM, Brian Roberts wrote:
Thanks for the reply, Bob.   Yes, I've done all the connectors with De-Oxit and I thought that did the trick, but the howling noise came back after about a week.

Brian





Have you done a recent "connector cleaning"?. If not, I'd say it is time to do so. Just sitting there, internally the connector contacts will oxidize after 30 or so years.

So, one at a time, unplug each connector, then using a Q-Tip moistened with contact cleaner, scrub the male pins. Then plug the connector in and out a couple of times to wipe the female pins. Be sure you have aligned the connector correctly and that it is fully inserted. Move on to the next connector. Usually this method will correct a very large part of intermittent and strange issues.

NEVER spray anything into the radio, connectors, IC sockets and such.

73

Bob, K4TAX


On 10/26/2018 6:48 PM, Brian Roberts wrote:
Hello Gents--

I have a Ten Tec Omni VI that has an intermittent problem that comes and goes for no apparent reason. The radio can be transmitting or receiving just fine and then a loud howling noise comes on. When the noise comes on, all functions are lost (signal reception, mode selection, band change, audio gain, etc.). The radio can be turned off and then back on with no change. Resetting the processor doesn't help. Shutting the radio down for a day or so will bring it back to normal again. Normal operations may continue for
days or weeks before the howling noise appears unexpectedly once again.

I've found that pulling cable #56 on the Logic Board will stop the howling
noise. Plugging cable #56 back in restores the howling noise.

Has anyone had a similar problem with the Omni VI or can anyone give me any
guidance on how to go about repairing the radio? Thanks.

Brian K9VKY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>