Hi Guys
I been searching around the internet now for a while, I am about to build a
80m 4 square and and to cut coax for it. I am going to use black RG11 coax.
I have a MFJ 259B to measure velocity factor with?. It's about 10 years
since I did previous time, and now I thinking about to build a 80m 4 square.
So I have a few question for you.
1. Is it any difference measure 75 or 50 ohm ? I meant it should be X=1
if you used it on 75 ohm instead of X=0 on 50 ? this is on a ¼ wl 75 ohm
2. I have a RG-11 75ohm coax I plan to use, but I am not sure of the VF
all my friends says is should be VF 0.66 ?
To use the MFj 259 B ...
What I believe I did previous time I was making cables for a 40m 4 square I
did?
1. to cut the coax on 14,5 meter
2. Solder one connector in the end
3. connected it to the MFJ 259.
4. Measure on 3675
5. Cut until X=1
I meant I saw a footnote into the old manual about "this" way of measure 75
ohm instead of 50 ohm? but I cannot find any reference in any topic on the
net.. I tried to email W8JI, but reply.
The Comtek ACB-4 80m says it need a ¼ wl 75 ohm coax as I remember. But I
saw here in MFJ 259B manual you can measure 1/4, 3/4,1-1/4, etc.
So does the 4 Square accept if I use ½ wl of 75 ohm to each vertical ? what
will happen?
If I cut one ¼ wl on 3,675 khz is 20,40 meter x 0,66 VF = 13,47 m + 5 %
extra for tuning ? = 14,14 m. it will be too short for get across between
two verticals.
I am worried about the length of this coax since I plan to have the feeding
point of each vertical @ 2.5-3 m above the ground.
I found out that my if I have a 20.5 m x 20.5 m square and the it will be
29,05m across? so then the coax of 13,47-14,14m is not long enough?
29,05 / 2 = 14,525 m?. so the coax will be to short anyway?.
What is normal to do in a ¼ wl 4 square ? the coax can't be run as a
string in the air, I wanna have it smooth into the ground....
if I double the length ? it will be about 26,8 +/. Meter.
Will the coax work ok? if I plan to have the feeding point on 2,5-3m above
the ground on 2 x 2?x6? wooden poles on each vertical.
Can anyone tell me How wide is a 80m 4 square in frequency ?
73s Rag LA6FJA
LN5O in contest also:K3RAG SO5RAG
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|