Another reason to be leery of crimp connectors. My soldered connector stubs
are still fine after 25 years at 2 locations in very high humidity
enviroments.
Carl
KM1H
----- Original Message -----
From: "Jim Brown" <jim@audiosystemsgroup.com>
Cc: "TopBand" <topband@contesting.com>
Sent: Thursday, June 21, 2012 12:15 PM
Subject: Re: Topband: Chokes for Beverages
> On 6/21/2012 8:47 AM, Guy Olinger K2AV wrote:
>
>> I have recently replaced some "RG-6" in use for maybe seven or eight
>> years. I opened it up to see what was happening. The degree of
>> oxidation on the inside and outside of the foil was perplexing. One
>> could easily draw a thumbnail along either side and build up a little
>> pile of oxide. The foil itself had become very brittle. It had been
>> "sealed" and treated outside.
>
> In the most recent version of his excellent book on Interstation
> Interference, George, W2VJN, noted that he had observed deterioration of
> stubs made with LMR400 that had been stored in his garage for a period I
> seem to recall was on the order of 8 years. Although a properly
> installed connector (and no doubt that George did that) should make
> excellent contact with the braid, which is tinned copper, differential
> current will be on the inner surface of the shield, which is foil.
>
> 73, Jim K9YC
>
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2433/5083 - Release Date: 06/21/12
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|