I replied to Dan directly that I had a very similar antenna and switch here,
with the box only being a few feet away from the switch and no issues.
I just had another thought. Is the series capacitor he is using of ample
size/voltage rating? Maybe it's arcing @ higher power ?
VE9AA
Mike, Coreen & Corey Smith
699 Rte 616 Keswick Ridge
NB
Canada
E6L 1T1
----- Original Message -----
From: Paul Dulaff
To: Dan Bookwalter
Cc: topband@contesting.com
Sent: Sunday, January 01, 2012 2:27 PM
Subject: Topband: Fwd: Re: More Inv-L matching issues.... BIGGER ISSUE
Dan
I understand that your 160 meter station is/was working until you
introduced the 374A to the system.
If this is the first time you have manually loaded up the 374A on 160
meters, it may be possible that the amp is tuned up for output on 80 meters.
C18 (tune cap) is the only capacitor in the tank circuit, so is possible to
reduce its capacitance down to tune on 80 meters when the bandswitch is set
for 160 meters.
It is possible to input to the amp on 160 meters, having the output tank
circuit tuned to 80 meters and the amplifier develop an output. The
amplifier in this case would be acting as a frequency doubler and would
output high power at 2X the desired frequency. The impedance at the antenna
would be completely wrong in this situation and would explain the immediate
failure of the relay box.
As a check, confirm that C18 (tune variable capacitor) is at full mesh
(max. capacitance). Tune and load the 374A into a dummy load, slowly
decreasing C18 until the first dip in plate current is noted.
Best 73's
Paul - WB2NMI
----- Forwarded Message -----
From: Paul Dulaff <pdulaff@embarqmail.com>
To: Dan Bookwalter <N8DCJ@YAHOO.COM>
Cc: topband@contesting.com
Sent: Sat, 31 Dec 2011 20:21:44 -0500 (EST)
Subject: Re: Topband: More Inv-L matching issues.... BIGGER ISSUE
Dan
A couple of thoughts...
When transmitting, is the RCS-10 antenna switch inadvertantly changing
(switching) antennas (ports) during the transition from receive to transmit,
possibly RF getting into the switching circuit causing this ? Do you lose
the 12VDC to the switch when changing from receive to transmit ? Are you
trying to support semi-break-in with the RCS-10 ?
The ratings on this switch are fairly good. 16 amps, 1200 volts. I would
think that it would need to be feeding an open or a short to fail this
quickly at this power level or switching at full power.
Paul - WB2NMI
----- Original Message -----
From: Dan Bookwalter <n8dcj@yahoo.com>
To: topband@contesting.com
Sent: Sat, 31 Dec 2011 17:34:09 -0500 (EST)
Subject: Topband: More Inv-L matching issues.... BIGGER ISSUE
Ok...
I went and added 9 more radials the SWR is now at 1.2:1 after some
adjusting of the air variable....
well , i decided to see how the amp (Alpha 374A) loaded into the antenna ,
I keyed down with maybe 500 watts and everything went dead again in less
that 1 second. So it now appears that I have smoked another relay in the
RCS-10 .
One thing about this configuration is that the base of the antenna is
about 16" from the RCS-10 , is this too close ? I can probably move it so
that it is about 4' away if that is the issue.... I cant afford to keep
destroying relays and such....
thoughts ?
Dan N8DCJ
________________________________
-----Original Message-----
From: topband-bounces@contesting.com
[mailto:topband-bounces@contesting.com]
On Behalf Of Dan Bookwalter
Sent: Saturday, December 31, 2011 2:41 PM
To: topband@contesting.com
Subject: Topband: More Inv-L matching issues....
well about a month ago i put up my Inv-L , it is now ~165ft , I have an
air
variable in series , and 12 radials anywhere from 150-250ft long ( going
out
to add more as soon as i am done typing this). my SWR wasn't too bad maybe
1.7:1 at the best. Two nights ago I added an amplifier to the mix ~700w ,
well to make a long story short I smoked one of the relays in my RCS-10 ,
I
am now not too sure what to do , I don't want to keep blowing out relays
in
the RCS-10.
I had several responses back then regarding matching etc... , but , in my
haste i seem to have deleted them :-(
so here i am again asking for advice...
any help greatly appreciated
Dan N8DCJ
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.1901 / Virus Database: 2109/4714 - Release Date: 12/31/11
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.454 / Virus Database: 271.1.1/4115 - Release Date: 12/31/11
19:33:00
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|