Tom,
Just purchase the splice connectors made for the cable. They are relatively
inexpensive and are applicable in a few minutes time as long as you also
purchase (one time purchase) a coring tool for preparing the ends of the
cable.
I have deployed approaching 30,000 feet on 1/2" CATV line in two extensive
Beverage antenna 'farms'. Doing it correctly the way it was designed will
save you time, grief, frustration and failures in the long run.
The same goes for the female "F" connectors for terminating the cable at
both ends. Inexpensive and very easy to install.
YMMV. Mis dos centavos.
de Milt, N5IA
-----Original Message-----
From: THOMAS M GREENWAY
Sent: Wednesday, April 03, 2013 11:05 AM
To: topband@contesting.com
Subject: Topband: CABLE TV HARDLINE
Just wanting some input ... I have used cable TV hardline for years with
most of the transitions being inside a plastic box with the center conductor
soldered to a SO239 mounted on the box and the shield being jumpered by
braid. Recently on some receive system fed with hardline I have used the
brass 1/2 transistions to joint the coax and a PL259 using NoOx. It makes a
nice neat transistion. The price is about the same to do either. I am
planning some large changes and leaning toward the brass transitions. Any
comments on experiences with both. 73 Mike K4PI
All good topband ops know fine whiskey is a daylight beverage.
_________________
Topband Reflector
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3267 / Virus Database: 3162/6224 - Release Date: 04/04/13
All good topband ops know fine whiskey is a daylight beverage.
_________________
Topband Reflector
|