Hi Gents,
I was considering several methods of building a common
mode choke for my Beverage coax line. I wanted something
that was small and could fit inside an existing box. Small
coax wound on a core was an option, but then I didn't have
a large enough ferrite toroid to use.
Then it dawned on me that a simple twisted-pair transmission
line might work. I made a few tests with some rather crude
instruments with some tightly twisted #26 enamel wire
and one #73 binocular core (the same kind made "famous"
by Tom, W8JI.
I wound 6-1/2 turns of the line through the core exiting
at opposite ends. Here's what I observed (again, crude instuments
were used)....The twisted pair transmission line impedance
measured about 60 ohms, and the common mode choke
impedance measured about 1950 ohms reactance at 1.8 Mhz.
If the relatively low breakdown voltage of the enamel wire insulation
could be tolerated, I see no reason why a choke like this couldn't
be used, that is if the above measurements are reasonably correct.
Could someone with better instruments and the cores make
some measurements on the described choke and make a quick report?
73,
Charlie, N0TT
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.
|