On Fri, Sep 21, 2007 at 05:37:44PM +0100, Neil Carr G0JHC wrote:
> I have recently acquired a Kenwood TS950SDX with a full set of cw filters
> down to 250Hz, the down side of this radio is the one ant socket and no
> ability to switch to a separate rx antenna using the rigs rx ant and
> internal relays. (automatically).
>
> Currently I am switching to my rx ant (an EWE) manually at the end of each
> transmission using a 2 way antenna switch, this method comes with a high
> risk of human error when the operator forgets to switch back and I have to
> nip out side to replace the 9:1 core, or resistor.
>
> Whats out there on the market that would do this switching automatically for
> me with just one ant port on offer from the rig?
>
> What do you guys do in this situation?
I use a MFJ-1026. It will do more - but works FB for just putting the
RX antenna into the SO239 during receive. Just turn down the ANTENNA
GAIN to zero. I even run the amp PTT to it so I don't have to use it's
RF detector and TR delay.
Tree N6TR
tree@kkn.net
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|