:::: This is a normal happening with most noise blankers and strong
signals. I'm surprised that you have never experienced this before. I
run into this all the time when stations using their noise blanker hear
my signal very strong and complain that my signal is in several places.
I advise them to temporarily turn off the blanker and the problem will
go away. If your blanker is variable, try turning it down; or better yet
avoid using it and rcve on your Beverage....if you have one.
BILL K4OWR
On 12/8/2015 10:56 AM, Larry - K1UO wrote:
Hello all.. This AM on 160 meters there was a station CQing on 1.820.6 with
a fundamental freq signal strength of S9 on my K3. I also found (with the NB
on) that I could hear him Q5 but very weak on 1.810.6 and the same S 0 reading
but perfectly Q5 on 1.830.6. I turned the noise blanker off and of course the
images disappeared. Is this a know problem when using the NB or is this just
with my radio after a recent factory alignment? I have had a K3 for years and
never noticed anything like that before but then again this AM was very quiet
on 160M and I had the NB on because I could hear a distant tick tick of an
electric fence.
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|