Mark,
I'm planning to have the termination value adjustment excercice for F/B
maximisation using a BC station signal. However, does SWR measurement have
to do also with the termination value? Or that's rather the matching
transformer that I should act on?
I now have an antenna analyzer and multimeter. What kind of optimization I
can carry out? (The beverage is permanently installed).
73 Ash
On Wed, Jul 4, 2018 at 3:23 PM <pa5mw@home.nl> wrote:
> Based on my field installed beverages experience, I would say this is
> exactly what I always read on my ant analyzer.
> Ground and local air/bush moisture level changes, like after rain or such,
> will affect readings too.
>
> I would do optimization only if this installation was permanent and you
> have
> the time and tools available.
>
> 73 Mark, PA5MW
>
>
>
> -----Original Message-----
> From: Topband <topband-bounces@contesting.com> On Behalf Of Ashraf
> Chaabane
> Sent: Wednesday, July 04, 2018 4:13 PM
> To: topband@contesting.com
> Subject: Topband: Beverage Antenna Tuning
>
> Hi All
>
> I measured the SWR in my beverage antenna; the SWR fluctuates between 1.5
> and 3 in a range of 1.8 to 7 MHz. (See:
>
> https://drive.google.com/drive/folders/0B9AtNpPfAOUMRDNsaXROMG1VUTg?usp=shar
> ing
> )
> I know SWR should not vary too much. However, some people are suggesting
> adjusting the termination resistor. Others suggest checking the transformer
> number of windings for a good match. What shall I do?
>
> 73 Ash 3V8SS/KF5EYY
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
>
--
Ash ~ 3V8SS/KF5EYY
http://www.kf5eyy.info/
Phone/SMS/Whatsapp: (+216) 22670026
Skype: kf5eyy
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|