The preamp shown in ON4UN's book (latest ed.) from the work of IK4AUY is
a very good one. A word of caution, however--there is a discrepency
between the bias resistor values from the ON4UN book and the article by
IK4AUY. I believe the values in the original article are correct. The
preamp is quiet and hard to overload--and in my experience terminates
filters properly.
Another comment. Make sure you NEED a preamp. If everything is well
matched and you have controlled any leakage into the system by decoupling,
grounding, etc. you may find that you actually have enough signal without
any gain. I used a preamp here for a long time, but when I went to work
on shield RF pickup/re-radiation problems and the like I turned the preamp
off and now I don't seem to miss it. Of course if you have miles of
feedline and a low-gain receiver your case may be different.
Ralph Matheny
K8RYU
207 Gibbons Place
Marietta Ohio 45750
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|