I?ve never run anything through conduit before.
I have a 100 foot long 3? conduit between house and tower, and in that
conduit I hope to run two ½? coax cables, three 3-wire ROMEX cables carrying
24V for three different rotators, two 8-conductor (CAT-5 like) cables for an
antenna switch, and three two-wire cables for the rotator position
indicators. It?s a good-sized bundle. There are no 110 AC power lines in
the bundle.
I think I need to pull all this at once, with lubricant, and include a
length of pulling rope or tape in the bundle for ?next time?. I believe
that I want to pull these through all at once in order to avoid risk of
damage to cables already installed.
What?s the right sort of lubricant for this? What quantity should I buy?
I have some light nylon ?fish? cord that I think I can pull through with a
small wadded up plastic bag and a shop-vac. After I have that pulled
through, I assume I attach it to a hefty pull cord. What sort of pull cord
should I be shopping for?
Any tips on tying the ?bundle? to the cord so that I have a smooth thing to
pull? I have Kellums Grips suitable for ½? coax, but not for anything else.
Is this a ?pulling eye??
I presume I want one person on each end that can communicate, one to feed a
smoothed bundle in one end while the other pulls.
Should I tape the whole bundle together every few feet?
Thanks,
Dick, K6KR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|