Towertalk
[Top] [All Lists]

[TowerTalk] End feeding a half-wave vetical

To: <jimsmith@shaw.ca>
Subject: [TowerTalk] End feeding a half-wave vetical
From: "Dennis O'Connor" <k8do@mailblocks.com>
Date: Tue, 2 Aug 2005 08:19:14 -0400
List-post: <mailto:towertalk@contesting.com>
Jim,
My feeling is that this is much ado about very little... First, a 4 degree 
difference in MODELED takeoff angle on 160 is meaningless...The presence of 
power lines, house wiring, plumbing pipes, sewer lines, telephone wires, CATV 
cable, and on, and on, within the near field makes the model nothing more than 
a rough guide - very rough...   Everything metal out to 3 waves is going to 
have a major effect on your pattern...

Next the modeled TOA is only the peak point in the modeled wavefront... There 
is vertical spread to the TOA and I suspect that the TOA  -3dB points cover a 
20 degree vertical angle, at minimum, so that would be roughly a 10 degrees to 
30 degrees useable TOA ; a 4 degree change in the wavefront means nothing...  
The percentage of time the arrival wavefront on 160 favors a TOA below 10 
degrees is very small...

Third, the fable that an end fed half wave wire doesn't depend upon the local 
ground is just THAT, a fable... If you work the antenna against ground it 
doesn't matter a furry rodents fat pucker hole what the length of the antenna 
is - you are working the antenna against ground and the local ground is the 
major loss factor in gathering up the return currents, and the mid field ground 
of 1 to 10 wavelengths out has lesser importance only because the biggest bite 
on the signal has already been taken (not that the mid field is unimportant, 
it's just that we have zero control over it)...  

Now, if you feed the half wave vertical antenna as a doublet, then the local 
ground is shielded from having to supply return currents, to some extent but 
not completely, by the antenna balance, but ground at 1- 10 wavelengths out is 
still going to play a major role... TANSTAAFL
And, Mininec way over estimates the low angle gain of vertical antennas over 
ground... Take those gorgeous low angle patterns it shows with a large dose of 
salt...

My instinct here is that you will be far better served by sticking to quarter 
wave elements with smaller and cheaper balloons, and putting up a phased 
pair... Use Al Christman's phasing lengths for the coax... a tuner at the 
transmitter will allow you to move around the band with minimal losses...  And 
switching from broadside to endfire will allow directional gain, which will 
help you hear the stations answering you......

cheers  ...  denny - never at a loss for an opinion
_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless Weather 
Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any questions 
and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>