Hello:
I just installed an older but good condition Telex Hy-Gain HG70-HD crank-up
tower. It's been vertical, but I have it hinged down at the moment to
install the rotor.
At the top, it has a "sleeve bearing". Then, on the top plate, there are
three holes around the mast hole, spaced 5" apart. I hope these holes are
for mounting a thrust bearing! If so, what type(s) of thrust bearing would
fit here, and where would I obtain one?
Thank you,
Barrie, W7ALW, Missoula, Montana
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 96 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|