Towertalk
[Top] [All Lists]

Re: [TowerTalk] Too much showing :-)

To: "Nick Pair" <daweezil2003@yahoo.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Too much showing :-)
From: "K8RI on Tower talk" <k8ri-tower@charter.net>
Date: Sun, 2 Jul 2006 14:33:09 -0400
List-post: <mailto:towertalk@contesting.com>
----- Original Message ----- 
From: "Nick Pair" <daweezil2003@yahoo.com>
To: <towertalk@contesting.com>
Sent: Sunday, July 02, 2006 12:07 PM
Subject: [TowerTalk] Too much showing :-)


> Too much concrete base showing with 9'x9' base slab brought to surface? 
> Why not a simple box a foot or >
>so bigger than tower footprint for the last 6 inches or so. Just backfill 
>the rest of the area with good soil over

This is what I did:  http://www.rogerhalstead.com/ham_files/tower14.htm 
Grass has now grown up around it so not much more than the top shows.  Be 
sure to crown it so water runs off. This is particularly important up here 
in the frozen north, albeit we are a longggg way from frozen today. Last 
night's low was around 80.

>the remaining slab, plant grass and nobody will know the difference. A 
>simple square out of 2x6's will suffice.

I just used 2 X 4s

>Place over the pour at last moment and the concrete slump will hold it in 
>place, not allowing the box to float >up, and finish it after it sets up 
>for 15 minutes or so. It'll give you a small surface slab over the unformed 
>big >base.

I set the form up as the last part of the pour: I had a form flush with the 
ground surface.  When we reached that I set the "Hexagonal" form in place. I 
had no problem with it floating up. I did use high strength (high fiber) 
concrete.  If need be you can nail or screw the smaller form to the top of 
the main form.  It's very easy to make.  First a square and then cut a piece 
to fit each corner with the ends cut 45 degrees.  You do have to calculate 
the length so the sides are all the same.

Just as an afterthought for a 9 X 9 area you might need to make a raised 
support for the center form (allowing the trowling of the main surface) and 
extend the center form down from that.  In my case I just set the smaller 
form on top of the larger and hit it with a hand trowl as the other surface 
wasn't going to show and I only needed to get rid of spots where water might 
collect and freeze even though it is covered with dirt.

Roger Halstead (K8RI and ARRL 40 year Life Member)
N833R - World's oldest Debonair CD-2
www.rogerhalstead.com
>  Just a thought,
>  Nick WB7PEK
>
>
> ---------------------------------
> Do you Yahoo!?
> Everyone is raving about the  all-new Yahoo! Mail Beta.
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>