I had a 160' tower with 5 TIC rings. For 160m I used a 1/4 wl wire vertical
hung from one of the guy wires. It worked well and I avoided any RF
problems to the rotators which can occur with shunt feeding.
John KK9A
To: TowerTalkSubject:
Re: [TowerTalk] Stepper Antennas and Shunt Feed Towers
From: "Dick Green WC1M"
Date: Thu, 1 Feb 2007 00:32:58 -0500
List-post: <mailto:towertalk@contesting.com>
I have a related question: How close to the tower can the shunt wire be?
I'm putting up a 3-stack of 4-el SteppIRs on TIC rings (the top one is up
already.) A shunt feed wire would have to be threaded through the TIC rings,
giving it only a few inches of clearance from the tower and ring. Assuming I
can fabricate standoffs that will keep the wire from touching any metal
parts, will the proximity of the wire to the tower and/or ring cause
problems? One person suggested spacing the wire further from the tower
between rings, then looping in to thread through each ring. Any reason to do
that?
Perhaps I should consider a different type of antenna for 160m?
73, Dick WC1M
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|