Towertalk
[Top] [All Lists]

Re: [TowerTalk] Lift Mast to Replace Rotator

To: <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] Lift Mast to Replace Rotator
From: "W3YY" <w3yy@cox.net>
Date: Thu, 26 Dec 2019 19:46:22 -0500
List-post: <mailto:towertalk@contesting.com>
John -

Next time install two bearings that provide both lateral and thrust support.
And then install the mast so there is no weight on the rotor.  Then you can
easily remove and replace the rotor.

73, Bob - W3YY


-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of John
Sloop
Sent: Thursday, December 26, 2019 5:02 PM
To: TowerTalk@contesting.com
Subject: [TowerTalk] Lift Mast to Replace Rotator

I'm looking for suggestions to lift mast, with antennas just enough to
replace the rotator, which is a Ham III.  Rotator is shelf mounted about 2
feet below the top thrust bearing.  All ideas are appreciated.

 

John S.

AA0ES

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>