Looking at my PT-2, the pointer is at 5. The label just under the sliding
pointer says "Gauge is calibrated. May not read Zero at rest."
73 Keith NM5G
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Tom WA9WSJ
Sent: Wednesday, January 11, 2006 4:35 PM
To: TowerTalk@contesting.com
Subject: [TowerTalk] Loos Gauge model PT-2
Hello Team,
I just picked up my Loos gauge to check the guy tension on my towers and
noticed that the pointer is not resting on zero, as I would expect, but
rather between 3 and 4. I can't push it any further toward zero because it
is at the end of its travel. No broken or bent parts etc. I would like to
think that I would have noticed this before and that it originaly was at
zero but I can't remember.
In any case, what is the collective wisdom about this?
Has anyone else seen this problem? Or do I have a fluke, no not the meter
:-)
Tom
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com _______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|