Towertalk
[Top] [All Lists]

Re: [TowerTalk] Steam Pipe for Masting

To: "Towertalk" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Steam Pipe for Masting
From: "Tom Osborne" <w7why@verizon.net>
Date: Sun, 13 Aug 2006 20:43:49 -0700
List-post: <mailto:towertalk@contesting.com>
Also, if it has had steam run through it, I'd imagine it is pretty rusty 
inside.
Tom W7WHY



I would not use it for mast material.  You want something like high carbon
steel or 6061-T6 aluminum.  Steel is about twice as strong as aluminum in
the same OD size and wall thickness, so it is the best choice for longer
masts.

73, Keith NM5G

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of AA6DX - Mark
Sent: Sunday, August 13, 2006 9:02 PM
To: TowerTalk
Subject: [TowerTalk] Steam Pipe for Masting

Howdy TTers .. I have available some 2Ø' sections of black steam pipe, 2.5"
(OD? ID?)  --- Heavier than regular pipe .. apparently bent at the ends, so
'bout 17' good ..  Anybody know about using such piping for masting?  I
guess would be good for holding up other pipes for dipole ends, but ...
wondering if would work for yagi stacks ???   Going to go have a peek
tomorrow.  $25 each seems reasonable..  73 Mark Nelson  -  AA6DX

mailto: AA6DX@ARRL.NET

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>