http://salem.craigslist.org/tls/486136497.html
10 bucks, can't be bad.
Mike K6Br
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of RICHARD SOLOMON
Sent: Friday, December 28, 2007 3:49 PM
To: n7ka@comcast.net; TowerTalk
Subject: Re: [TowerTalk] Drilling tubing (180 deg)
The Portalign is an interesting fixture. Too bad the company went out of
business years (30 +/- ?)
ago. Anyone have one they want to sell ??
73, Dick, W1KSZ/7
ject: [TowerTalk] Drilling tubing (180 deg)> > Using my previous paper for
marking a cut line, remove paper from tubing ande flatten it out making a
crease in the paper. Each crease is 180 degrees from the other. result a NO
measurement method of finding opposing holes for drill in round stock
material. Just slide the pper back over the tubing and mark the tubing at
the crease. All this takes is paper, some Scotch tape, and a pencil.> > For
small tubing a "PORTA-LIGN fixture on a hand drill will provide a good thru
hole. Used this method to make 4X14el 2M yagis and 8X16el 432MHz yagis.> >
Arne N7KA> _______________________________________________> > > >
_______________________________________________> TowerTalk mailing list>
TowerTalk@contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|