Re: [TowerTalk] Vendors for 1 3/4 inch mast material?

["Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>]

>I have a Rohn top section which has an OD of 2 inches, so it will only
> accept a 1 3/4 inch mast inside it.I've found vendors on the web for 2 
> inch
> mast, but none for 1 3/4 inch.

How about inch and a half schedule 40 pipe? It should just fit. Otherwise 
you could have a couple of bushings/sleeves made and use 1 1/2" tube.

Roger (K8RI)
>
> Does anyone out there have a link for the smaller diameter mast material?
>

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk