Towertalk
[Top] [All Lists]

[TowerTalk] Guys & Towers CORRECTION

To: <towertalk@contesting.com>
Subject: [TowerTalk] Guys & Towers CORRECTION
From: aa0cy@robertwanderer.gardnerville.nv.us (ROBERT WANDERER)
Date: Wed, 4 Jun 1997 20:39:27 -0700
Oops, that should be about 1/2, not 1/3rd. 
For those who are concerned about the turnbuckles, you need to run wire or 
strap from
a feet feet above the turnbuckles to the guy ground system.
Think INDUCTANCE, not resistance. The Vd due to inductance is far higher and of 
greater
concern than the Vd due to resistance. A 150' tower with 35" sides has a total 
resistance of
about 0.001 Ohm but 40 microHenries of inductance. 
Emblaze this formula Vd=L (di/dt) on your foreheads!
73, Bob AA0CY

----------
From:  ROBERT A. WANDERER[SMTP:bobwanderer@polyphaser.com]
Sent:  Wednesday, June 04, 1997 6:48 AM
To:  no9z@prairienet.org; towertalk@contesting.com
Subject:  [TowerTalk] Guys & Towers


     Lynn
     
     All things being equal, a truly guyed tower (i.e. conductive and 
     uninsulated) will have a voltage gradient between top and bottom 
     of approximately 1/3rd that of a tower which is either 
     freestanding or the guys are nonconductive or have insulators in 
     them. Note that the TOTAL current will be the same in both cases 
     as lightning is a constant current generator. But what you are 
     achieving with the guys is current sharing (parallel paths). 
     Since Vd=L (di/dt), the Vd associated with the tower will be less 
     because the di is less down the tower.
     
     BTW, 2 or 3 ground rods at the base of the tower is insufficient 
     as a good lightning ground. The scenario in the first paragraph 
     also assumes a proper lightning ground is employed where the guys 
     are anchored. We are, nevertheless, comparing apples to apples 
     based upon the scenario you presented.
     
     Several years ago, the myth that uninsulated conductive guys 
     would affect the beam pattern was dispelled in a QST article.
     
     Hope this helps!
     
     Sincerely & 73,
     Bob Wanderer (AA0CY)
     Senior Applications Engineer
     PolyPhaser Corp.

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm



--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Guys & Towers CORRECTION, ROBERT WANDERER <=