Tom, you were correct about the rising Z. Thanks so much.
I found out why the input Z was going up as I put more radials in...I was
measuring at the end of 55' of LMR-400 (as opposed to the measurements I
took when I was outside originally tuning the antenna.), and that was acting
as a 1/4 wave transformer.
I just went outside and connected through an 18 inch jumper to the MFJ-269
and got the following measurements:
2:1 VSWR Low freq Point: 3460 khz
2:1 VSWR Hi freq Point: 3801 khz
2:1 VSWR Bandwidth: 341 khz
Fo (Resonant freq) = 3560 khz, 40 ohms resistive, 0 ohms reactance
3500 32,9 1.6
3550 38,0 1.0
3600 44,9 1.2
3650 52,19 1.4
3700 57,30 1.6
3750 63,35 1.8
3800 69,39 2.0
Above table: freq, R,+/- j, VSWR, all taken from the MFJ-269
If the radiation resistance is 26 ohms and I measure 38 ohms feed impedance
at resonance, then apparently I have 12 ohms of ground loss, for an
efficiency of:
26/(26+12) or 26/38 = 68%
At least, that's where I'm at for the moment. Time for another 8 radials.
That 1/4 wave transformer (55' of LMR-400 between feedpoint and shack) that
Tom, W8JI, pointed out, makes a big difference in my confusion...at least it
all makes sense now.
I think this system is behaving pretty "traditionally" at this point,
narrower bw is showing lower ground return losses, and the feedpoint Z is
now believable. Assuming that Devoldere's spec of 26 ohms for a .16 lambda
vertical inverted L (the rest being more or less horizontal off the top),
then my ground losses are in the area of 12 ohms with the 8 radials I have
out so far (66' long)
Thanks again, Tom.
73,
...hasan, N0AN
----- Original Message -----
From: "Tom Rauch" <w8ji@contesting.com>
To: "hasan schiers" <schiers@netins.net>
Cc: <towertalk@contesting.com>
Sent: Saturday, September 03, 2005 3:48 PM
Subject: Re: [TowerTalk] Rising Input Z with more radials?
>> Radials 2:1 Fo 2:1 BW Z VSWR @ Fo
>> 0 3340 3522 3920 580 36,0 1.3
>> 2 3354 3524 3774 420 45,0 1.0
>> 4 3419 3533 3741 322 60,1 1.2
>> 8 3445 3550 3742 297 65,4 1.3 (reactance would not go
> lower than 4)
>>
>> The formatting is bad, but in order, left to right:
>>
>> Number of Radials
>> Lower 2:1 vswr point
>> Resonant Freq point (Fo)
>> Upper 2:1 point
>> Bandwidth in kilohertz
>> Impedance (R,+/- j) at resonance as shown on the MFJ 269 .
>>
>> I'm a bit confused by the rising feedpoint impedance with
> increased radial
>> numbers, yet the narrowing down of the 2:1 swr bandwidth
> does indicate
>> decreased losses.
>
> You are measuring through a 1/4 wl transmission line
> transformer, the 55 foot LMR feedline.
> As input impedance at the antenna becomes less, impedance at
> the analyzer is higher because of the "Q" section.
>
> All that aside, I would never depend on bandwidth or
> impedance as an indicator of efficiency unless you have a
> very good feel for how the system behaves. While there are
> many cases where it is an indicator, there are also many
> cases where the results are counter intuitive and a narrower
> SWR BW and lower impedance antenna is less efficient!
>
> 73 Tom
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
> Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
> any questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.344 / Virus Database: 267.10.18/89 - Release Date: 9/2/2005
>
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|