HI Gary
Have the loop below the boom works very well here. You have to have a safe
climber in place for the installation and it check out 360 degrees while
someone in the shack (linked by radios) operates the control box. Take measures
to insure the coax can never get caught by the guy attachment hardware. The key
to this is coming off the boom about 3 feet away from the tower face.
73
Tim K3LR
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
StellarCAT
Sent: Sunday, March 24, 2019 1:56 PM
To: Tim Duffy; 'tower'
Subject: Re: [TowerTalk] how to do coax on ring rotor?
Thanks Tim ... as I wrote David direct - it was a "DUH!" moment when I read
his note - which was to use the truss support upright. I have been focusing
too much on the actual antenna and the coax along the boom .... thinking
loops around the tower and drapes etc.... I hadn't even considered the truss
support. That should be pretty straight forward.
I do have a guy right below, within 3', so I'm reluctant to let it hang down
directly from the boom .... although it looks like that is what you do Tim.
Gary
K9RX
-----Original Message-----
From: Tim Duffy
Sent: Sunday, March 24, 2019 12:27 PM
To: 'StellarCAT' ; 'tower'
Subject: RE: [TowerTalk] how to do coax on ring rotor?
Hello Gary:
You can go to my website and see lots of photos of coax with ring rotors.
There are 23 ring rotors here - so if you have questions after looking at
the photos and videos - please email me and I will help
http://www.k3lr.com look at contest photos and videos
73
Tim K3LR
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
StellarCAT
Sent: Sunday, March 24, 2019 12:00 PM
To: tower
Subject: [TowerTalk] how to do coax on ring rotor?
I’ve got two TIC ring rotors that are going up – hopefully this spring ...
they’ll have 2 7 element 10’s on them ... (yeah, I know, 10M’s).... and I’m
trying to figure out the best way to handle the coax coming off of the
antennas. Both going up from the ring as well as going down. I need up
because one of the rings will be mounted 4’ above a guy point so going down
isn’t likely to be a solution.
Anyone done this already and gone through the trials and tribulations of
getting it right?
You’re welcome to write direct to my ARRL email address or post here...
thanks – Gary, K9RX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|