Here's another one:
https://www.grainger.com/search?searchQuery=UCF210+32
Amazon also has them... If you like Amazon.
I have had one of these up on 3 different towers at 3 locations. Been up for 30
years with heavy masts and TH6/7 and 2 element 40. Both on R25 and R45.
Still works perfectly.
73
Jim W7RY
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
knowkode@verizon.net
Sent: Saturday, October 6, 2018 10:57 AM
To: towertalk@contesting.com
Subject: [TowerTalk] thrust bearings
Greetings All,
I have used Rohn TB3 thrust bearings in the past without issue but I have seen
my fair share of worn out bearings due mainly to an antenna being parked in
one direction for a long time- pitted races were the result. I've no experience
with anything else and that brings me to my question. Is there something better
out there? DXE claims an improvement over the Rohn bearing but it looks as all
they did was add a lower seal. I'm leery of Yaesu if the bearings are made from
the same pot metal as their rotor mast clamps. Bearing recommendations for an
installation with a 2" mast with about 8' above the bearing and 2' below and
an antenna along the lines of JK's C3S antenna are sought.
Tnx es 73,JimW5QM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|