No doubt. But I’ve been using one since 1986 and it’s still FB. It’s been
carrying the load of a 10’ 0.125” galvanized steel mast, a 40CD2, a DW3, and a
KT-34A, and a couple of VHF/UHF antennas.
Kim N5OP
"People that make music together cannot be enemies, at least as long as the
music lasts." -- Paul Hindemith
> On May 30, 2021, at 5:26 PM, john@kk9a.com wrote:
>
> In my opinion there are better tower bearings available.
>
> John P4/KK9A
>
>
> K1RX wrote:
>
> Hello group!
>
> Could someone here give me the precise inside diameter of this bearing?
> Quick checks in the Rohn catalog (over 230 pages) I was unable to find it.
>
> Thanks!
>
> Regards,
>
> Mark, K1RX
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|