Towertalk
[Top] [All Lists]

Re: [TowerTalk] hy-gain th6 trap rebuild

To: chris casey <cscvrp@gmail.com>, towertalk reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] hy-gain th6 trap rebuild
From: GALE STEWARD <k3nd@yahoo.com>
Reply-to: GALE STEWARD <k3nd@yahoo.com>
Date: Mon, 2 Apr 2012 11:28:32 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I've seen these referred as "spider spacers" probably due to the design of the 
cutouts in the center to clear the hardware, etc. I had a bag of these that I 
obtained when I purchased a 14AVQ from a local ham. I'm therefore assuming that 
these parts are available from MFJ/Hygain, or at least they were at one time.

I used up all the ones that I had when I rebuilt my TH6 last fall as, I too, 
found most of them cracked  and I wasn't able to reuse the ones that came out 
when I open up the traps.

I would like to buy a dozen more to keep on hand.

Maybe someone on TT has some better info.

73, Stew K3ND





________________________________
 From: chris casey <cscvrp@gmail.com>
To: towertalk <towertalk@contesting.com> 
Sent: Monday, April 2, 2012 12:15 PM
Subject: [TowerTalk] hy-gain th6 trap rebuild
 
After getting out tower down and getting a look at it, several traps
were missing their internal spacers. They had disintegrated and fallen
out after the black caps did the same, the can then shorted across the
coil. Both the 10M driven traps had done this, and this helps explain
why the tuner in the rig would not be happy with 10M.

So being cheap, I brought the 10M coils home and cut up an old cutting
board and made some new spacers. This seems to be fine business
mechanically. I did the whole put it in the microwave and see if it
gets hot to see if rf cares about it, it came out cold. Its HDPE.

I need to make many more of these, another one exploded its spacers
when I pulled the trap apart this morning and several more look worse
for the ware after being exposed after losing their caps.  But before
I do so, I wondered if anyone saw any fatal flaw in this plan?

The spacers aren't identified anywhere in the antenna documentation,
only whole trap assemblies. I haven't asked hy-gain about them yet but
I will. Wonder if what I made wouldn't be a bit more sturdy.

Thanks

-- 

-Chris
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>