On Thu, Mar 11, 2010 at 2:05 PM, r miles <greenacres113@charter.net> wrote:
> I am putting two gusset plates to hold truss supports on my homebrew 30m
> Moxon. I'm using 1/4'' X 20 bolts. It's been 40 yr.s since I worked in a
> machine shop. Don't have the proper hole size chart for taps anymore. I
> assume the hole size to be threaded 1/4 x 20 is less than 3/16''. Anyone
> have a chart showing the proper size.TNX
> K9IL
Jim's got it, but for future reference:
http://en.wikipedia.org/wiki/Drill_and_tap_size_chart
<http://en.wikipedia.org/wiki/Drill_and_tap_size_chart>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|