Assume 100 watt power level, imagine now that 50 watts is carried by each
coax. Assume each coax has 3dB loss at the test frequency. Each coax will
lose 25 watts. Summed at the output, there will be 50 watts, a 3db system loss.
Remember that the RF voltage in a matched system will be lower by a factor of
0.707 in the composite coax due to the lower system impedance. That results in
half the dielectric (V^2) power loss (I^R is usually negligible).
-Mike-WA6ZTY
From: Hans Hammarquist via TowerTalk <towertalk@contesting.com>
To: towertalk@contesting.com
Sent: Thursday, August 4, 2016 10:50 AM
Subject: [TowerTalk] Losses in parallel coax
Jim,
That's something I don't really understand. Why do you get the same loss in
coax if you run them parallel? If you run "normal" wires in parallel you reduce
the losses due to the lower current in each from the conductor RI^2 loss and
the V^2 loss in the dielectric, even if that's not a big deal at, say, 60 Hz.
Why not the same for coax? Yes, if I parallel two coax I need to use some
matching to get the 50 ohm (or whatever I have).
Hans
-----Original Message-----
From: Jim Brown <jim@audiosystemsgroup.com>
To: towertalk <towertalk@contesting.com>
Sent: Tue, Aug 2, 2016 1:15 pm
Subject: Re: [TowerTalk] Flaky dipole
And as you probably know, the loss in dB in parallel runs of coax,
whether connected in series or parallel, is the same as in a single run
of the same coax.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|