Towertalk
[Top] [All Lists]

Rohn HDBX question

To: <towertalk@contesting.com>
Subject: Rohn HDBX question
From: aa7bg@initco.net (AA7BG Matt Trott)
Date: Sun, 6 Oct 1996 23:30:42 -0600
>    For a large-ish mast and stacked antennas on your HDBX, one of the crux
>bits is the bent tin plate that is supplied as the top plate of the tower; it
>probably isn't up to the task of holding your proposed system against big
>side forces.  If you beefed it up, that would help.  Are you going to install
>a thrust bearing?

Just came down from an HDBX 48 footer today where I was changing out the
rotor for a friend. Spent 2 and 1/2 hours up there. First thing I noticed
was that it's a very sturdy self supporter when put up according to specs.
Second thing I noticed is that the "bent tin plate" on top was torn in one
corner. DEFINITELY beef that puppy up! Better yet replace it with something
else. The tower I was on had a TET 4 ele tribander on it (20 foot boom?)
just above the top and an isopole 6 feet above that on 2 in mast. I would be
very hesitant to stack yagis on it, but then again, with a beefed up top
plate and the config Steve mentioned it might be worth a try. I wouldn't go
more than 5 or 6 feet spacing.

You MUST have a good pair of boots when working on this stuff and a good
pair of leather gloves. It was a pain in the rear swapping rotors. Used
strictly grunt power, cuz no gin-pole, etc.

73, Matt
AA7BG



--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P

<Prev in Thread] Current Thread [Next in Thread>