Oops, let me make a clarification on the elasticity comparison:
I failed to include that the relative elasticities among the materials
is for the same cross-sectional area! Sorry for the confusion.
It is possible to have equivalent stretch between steel and fiberglass
guy materials if the fiberglass rod is oversized.
Compared to a solid, 0.25" diameter steel rod, a fiberglass rod of the
properties previously mentioned would have to be about 0.25 x 2.2 = 0.55
in diameter to have the same deflection rate (spring rate)along its
length.
The cross sectional area of the fiberglass rod in this case would then
be about 2.2 squared = 4.8 times that of the equivalent steel rod.
The breaking strength of this fiberglass rod would then be about 28,500
lb, based on the strength of 120,000 lb/sq in given before.
Based on the densities of 0.282 lb/cu in for steel and 0.073 lb/cu in
as previously reported for the fiberglass, the weight per unit foot of
the fiberglass works out to be about 1.25 times that of the steel.
Since the fiberglass is a little stiffer, yet heavier per unit length, I
would guess that the sag would be close to or only slightly less than
the steel.
The point is, you *do* have to look at the 'stretchiness' of the guy
materials. The more 'stretchy' they are (low modulus), the more
oversized they must be for the equivalent stabilizing effect on your
tower.
FWIW,
--...MARK_N1LO...--
Get Your Private, Free Email at http://www.hotmail.com
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|