The Rohn 45 bearing plate that Array Solutions sells can be inserted at the
junction between tower sections and moved into position vertically. It can
then be tapped/hammered horizontal using a rubber mallet anywhere within a
section.. I am using such a method on my Rohn 45 tower and inserted the
extra bearing plate and rotor plate while working at the top of the tower
I hope this answers your question.
Mark N1UK
----- Original Message -----
From: "rfman45" <rfman45@hotmail.com>
To: <towertalk@contesting.com>
Sent: Tuesday, 03 May, 2011 4:35 PM
Subject: [TowerTalk] Rohn 45 Bearing Plate
>
> I am using Rohn 45 and want to put a second thrust bearing between the
> rotator and mast. The bearing plate p/n BPL45G can only be mounted at the
> top. Is there any way of putting a second bearing plate between the
> rotator and the the top baring plate?
>
> Thanks in advance!
> Mike W2LO
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|