Right next door to where I work is a place that did
just this for my Rohn 25 sections. I don't believe
they would have been able/wanted to remove any paint
(I had none so this wasn't an issue).
They had a 300# minimum and charged me ~$0.35 per
pound (that's per pound of my material, not of the
zinc) plus another $0.05 per pound to strip the old
zinc. At 40# per Rohn section, this works out be $16
a section.
Even though they cater to commercial entities (guard
rails, highway signs, etc.), they had no problem
dealing with my small order - just don't ask them to
rush! (It took about a week)
If you go this route - be sure to check all the hole
diameters and other clearances when you get the
material back. I had to grind off some zinc flashing
in places (but admittedly less than the crap I got on
brand new Rohn 45).
Mike N2MG
K4XS wrote:
Suggest you take it to a professional big galvanizing
place. They will strip it and regalvanize it. No
need to sandblast it unless it has been painted.
The local place here has a minimum charge of around
$450 to do the strip and regalvanizing.
That will cover the first 1000 pounds...much more
effective and long lasting.
W3AU had that done to his AB 105 down here in FL.
________________________________________________
PeoplePC: It's for people. And it's just smart.
http://www.peoplepc.com
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|