Good morning Dick
The G-1000SDXA will bolt up to the plate or the 45AG4? top section. I
run a similar set up that uses the Rohn TB-3 thrust bearing bolted to the top
section. Another plus is you can stand on the tower top section. Hope this
helps.
73 Joe K4XZ
>
> From: "Dick, W1KSZ" <w1ksz@earthlink.net>
> Date: 2007/08/25 Sat AM 08:24:33 EST
> To: TowerTalk <towertalk@contesting.com>
> Subject: [TowerTalk] Another ROHN 45 Question
>
> Will the AS455G Accessory shelf accommodate the YAESU
> G-1000 Rotator without additional drilling ?
>
> If you must know why I picked the YAESU, it's because
> the FT-2000D DMU has that neat rotot control app.
> --
> 73, Dick, W1KSZ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
JOE PATRICK
SENIOR PLUMBING/MECHANICAL
INSPECTOR CITY OF BOYNTON BEACH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|