In addition, the aluminum radials oxidize and turn to powder in a
short number of years (months?).
Copper or copper-coated steel for me.
73
Don
N8DE
Quoting Clint Talmadge W5CPT <w5cpt@bellsouth.net>:
> I tried it. It is springy enough that where my yard has dips it pulled out
> of the shallow cuts I made. That exposed them to the deer who stepped on
> them and broke them. Then I ran over the exposed ends with the mower and
> pulled some out with rather spectacular results to the spindle of the mower
> deck and bits of Kentucky clay flying up into the air.
>
> All my new radials are copper.
>
> Clint Talmadge ? W5CPT
>
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Peter Sils
> Sent: Thursday, December 30, 2010 6:46 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Using aluminum wire (or aluminum clad) - for buried
> radials?
>
>
>
>
>
>
>
>
>
>
> Gents,
>
> What are your thoughts about using this for buried radials?
>
> Your thoughts would be greatly appreciated!
>
> 73 Peter
> KD0AA
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|