Towertalk
[Top] [All Lists]

Re: [TowerTalk] Two tools to tighten PL-259 connector shells

To: "Ward Silver" <hwardsil@gmail.com>
Subject: Re: [TowerTalk] Two tools to tighten PL-259 connector shells
From: "Rick Karlquist" <richard@karlquist.com>
Reply-to: richard@karlquist.com
Date: Wed, 4 Jan 2012 12:28:32 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
They make a special tool for tightening F connectors
in tight spaces (remember the fun we used to have
putting them on VCR's :-).  It is a box wrench with a gap
in it to let the cable through.  Unlike ordinary box
wrenches, the handle exits axially, not radially.
If you soldered a nut to a PL259, then you could make a
tool like this to tighten it.  A half inch or 15/32 inch
panel nut might work.  (The nut has to be large enough
to slip over the cable.)  Unfortunately, you can't
retrofit a nut on an existing cable without redoing one end.

Rick N6RK

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>