I think you should make both antennas equal at the feed point. If you use
a balun on one you need to match that on the other. Make shure that
baluns are the same and connected the same.
Jim
At 05:31 PM 11/1/98 EST, AA4NC@aol.com wrote:
>
>I'm testing a 2/2 40m stack that uses a Cushcraft 402CD@70' and a XM240@130'.
>I'm feeding this with a WX0B stackmatch. The 402CD is directly coax fed with
>some ferrite beads over the coax , and the XM240 uses the Cushcraft MNXM
>balun.
>
>I'm finding the 2 antennas seperately to be close (within 3-5 dB of each
>other) as expected. What I find that bothers me is that the stack is almost
>always slightly weaker than either of the antennas alone. I wonder if it is a
>phasing problem?
>If so, the bottom antenna would be easier to test phase as I can tell which
>side of the driven element the center/ground of the coax are connected to. I
>need to find out what the phasing is on the MNXM balun for the top antenna so
>I can tell if the bottom is out-of-phase. Does anyone know how this balun is
>wired?
>
>Any ideas/suggestions would be appreciated.
>
>73,
>
>Will
>
>--
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Submissions: towertalk@contesting.com
>Administrative requests: towertalk-REQUEST@contesting.com
>Problems: owner-towertalk@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|