Towertalk
[Top] [All Lists]

[TowerTalk] Using Split Beads

To: <towertalk@contesting.com>
Subject: [TowerTalk] Using Split Beads
From: dhearn@ix.netcom.com (dan hearn)
Date: Fri, 12 Nov 1999 22:05:17 -0800
A small air gap causes considerable loss in inductance,Herb. You would
be ahead to get beads with a larger hole or possibly use a short section
of smaller coax. Could be RG8X if that will take the power you use. You
might consider removing a bit of the vinyl covering and then tape
overall. 73, Dan, N5AR

Herb Rosenberg wrote:
> 
> I ordered some material 43 split beads to place on rg8 coax.  It appeared
> to me that the coax had an outside diameter of 3/8 of an inch, so that
> was the size of split bead I ordered.  Now that I have the beads, the
> inside "hole" of the split beams is a bit small for the outside diameter of
> the coax.
> 
> So, my question is, is it essential that both halves of the split bead
> actually touch each other, to fully encirle the coax, to work optimilly,
> or will they still be effective, even if there is a small gap between the
> two halves of the split bead?
> 
> Any comments would be appreciated.
> 
> Herb - KG6OK
> 
> herbr@netcom.com
> 
> 
> 
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>