I think N4KG would have a lot of info on this, however I think
it will work just fine.
One example. I have a 20/15 duobander 4 el 20 and 5 el 15
on about 38 ft boom. Was going to tune it for 40m but since
it had a lot of loading from those 9 elements it ended up on
80m (huuh). The thing is only at 70 ft so it doesnt work very
good except for local QSO´s but it´s an antenna that can be
used.
I used Omega match and replaced half of the boom guy with
parafile/phillystran and did keep the steelwire on the other half
and used that as a gamma rod, used RG-213 for capacitors,
I have tested it with very high power and it´s no problem.
73 Jim SM2EKM
------------------------------------------------------------
Paul Young wrote:
>I have a three element 40 meter beam. I'm thinking about
>matching the boom as an 80 meter short dipole.
>
>The boom length is 48'. The driven element is insulated but
>the parasitic elements are connected to the boom. They are
>full size and provide plenty of end loading. It has a T-bar
>truss which is not insulated but I don't think I would want
>to use it to feed the antenna.
>
>The problem, of course, is feeding it. Tilting the antenna
>is difficult, but I figure I can tip it once and install
>some sort of omega rod. Then I can tune it from the mast.
>The bandwidth may be narrow enough that I'll need to put up
>a relay to switch it to phone.
>
>Has anyone tried this? What sort of omega rod will I need?
>Any caveats?
>
> Paul, K1XM
>_______________________________________________
>Towertalk mailing list
>Towertalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
|